How to fix COBHAM Transceiver if the system cannot be switched on?
If your COBHAM Transceiver SAILOR 6018 won't switch on, it could be due to a remote on/off switch being used. In this case, use the remote switch instead of the power button. Alternatively, check that all power cables between the ship power source and the SAILOR 6018 are correctly connected and that the power source is active.
What to do if there is no signal from the satellite on COBHAM Transceiver?
If you're experiencing a weak or absent signal from the satellite on your COBHAM Transceiver, first ensure that the SAILOR 3027 has an unobstructed view in all directions. If the view is clear, the issue might be that the system is configured for a specific satellite but is currently outside that satellite's coverage area. Try logging into a satellite that covers your current location.
What to do if COBHAM Transceiver SAILOR 6018 cannot switch off?
If your COBHAM Transceiver SAILOR 6018 won't switch off, it might be due to a software error. To resolve this, try pushing and holding the Power button for 10 seconds, or reboot the device by disconnecting and reconnecting the power cable.
How to fix no connection between SAILOR 6018 and SAILOR 3027 on COBHAM Transceiver?
If there is no connection between the SAILOR 6018 and SAILOR 3027 on your COBHAM Transceiver, the CAN cables might be damaged or improperly connected. Ensure the CAN cables are correctly connected and inspect them and their connectors for any damage.
Why is there no battery information in the SAILOR 6018 COBHAM Transceiver?
If your COBHAM Transceiver SAILOR 6018 is not displaying battery information, the Ethernet connection from the power supply might be faulty. Check the Link activity indicator at the connection points in the Ethernet switch, and ensure that the Ethernet cables are correctly connected and undamaged.
What to do if there is no connection between SAILOR 6018 and printer on COBHAM Transceiver?
If your COBHAM Transceiver SAILOR 6018 has no connection to the printer, the USB cable could be the issue. Check that the USB cable is correctly connected and is not damaged.
Why does COBHAM Transceiver SAILOR 6018 show “PR Out Paper” when there is paper?
If your COBHAM Transceiver SAILOR 6018 displays “PR Out Paper” even when the printer has paper, the paper might not be positioned correctly. Adjust the paper to the left side of the printer.
How to fix units in SAILOR 6110 not appearing in TMA for COBHAM Transceiver?
If the units in the SAILOR 6110 aren't showing up in the TMA (ThraneLINK Management Application) for your COBHAM Transceiver, the computer running the TMA might have a fixed IP address that doesn't match the local network with the SAILOR 6110 units. Enable DHCP on your computer. If you need to have a fixed IP address on your computer, there must be a DHCP server in the network, and the IP address of your computer must be within the range provided by the DHCP server.
General| Brand | COBHAM |
|---|---|
| Model | SAILOR 6110 mini-C GMDSS |
| Category | Marine Equipment |
| Language | English |
To Next Page
