98-137261-F 1
Chapter 1
Introduction 1
SAILOR 6390 Navtex Receiver
The SAILOR 6390 Navtex Receiver receives Navtex messages on the
international Navtex frequencies 490 kHz, 518 kHz and 4,209.5 kHz. It can hold
2000 messages per frequency. Messages are not affected by a power cycle.
Untagged messages are cleared from the message log after 66
1
hours, you can
tag messages for later viewing. You can customise which stations to receive
messages from and which message types you want to receive. The unit has an
alarm relay which is only activated if a message of category D is received (i.e.
SAR, Mayday relay, Pirate attack etc.). The SAILOR 6390 Navtex Receiver is
always on when powered. With its LAN interface the transponder and the display
can be separated, giving access to the Navtex information available where it is
needed.
The SAILOR 6390 Navtex Receiver is delivered as a black box receiver which can
either be connected to the SAILOR 6004 Control Panel, a 7" touch screen, or
used as a standalone unit for integration with an INS, supporting NMEA0183. A
printer can be connected to the receiver.
The SAILOR 6390 Navtex Receiver is approved according to GMDSS (EU Marine
Equipment Directive).
1. Default value.
Figure 1: SAILOR 6390 Navtex Receiver
To Next Page
Loading...
Need help?
General
