Alerts and notifications
28 Chapter 3: Service & maintenance 98-137261-F
Alerts and notifications
Introduction to alerts and notifications
The SAILOR 6390 Navtex Receiver reports alerts of the type warning and
caution, and complies with the requirements for Bridge Alert Management
according to IEC-62923-1 (2018) and IEC-62923-2 (2018).
Alerts and notifications are reported and indicated in the bottom bar of the
SAILOR 6004 Control Panel display.
Alert icons appear to the right and notifications just above the UTC time in the
bottom bar as shown.
An alert is presented with an alert icon in the lower right side of the display. An
alert can be of the type warning or caution. If a warning is not acknowledged the
audible warning signal (2 beeps) is repeated every 4 minutes until it is
acknowledged. The audible warning signal disappears when the alert changes
state from the initial active unacknowledged state, e.g. when it is acknowledged
or the alert is rectified.
You can display the current list of active alerts by tapping the lower right corner
of the SAILOR 6004 Control Panel display where the alert icon is displayed.
The alert list is prioritized. The most important alert is an alarm, then warning and
finally caution. The most important active alerts move to the top of the list, after
Figure 29: Icons for alerts and notifications
Alert icon
Notification icon
To Next Page
Loading...
Need help?
General
