Setting Dynamike®
This controls the microphone sensitivity
(outgoing audio level).
To Transmit
1514
Caution!
Be sure the antenna is properly
connected to the radio before
transmitting. Transmitting
without an antenna, or a
poorly matched antenna, could
cause damage to the transmitter.
Be sure to read the F.C.C. Rules
and Regulations included with
this unit before transmitting.
Operation
Operation
3
Select a desired channel.
1
Initially, set Dynamike fully clockwise so that
maximum voice volume is available. The Dynamike
may have to be reduced in some conditions.
2
Transmit
Push and hold the mic button to transmit.
When transmitting, hold the microphone two inches
from your mouth and speak in a clear, normal voice.
Release the mic button to receive.
Setting TalkBack
This control is used to adjust the desired amount of
modulation talk back present at the speaker during
transmit.
At the fully counter-clockwise position the TalkBack
is Off.