Cobra 29 LX MAX User Manual

3332
Operation
Operation
When switched to ANL the Automatic Noise Limiter is
activated. This helps reduce noise created by the vehicle’s
electronics.
When switched to NB/ANL mode the RF Noise Blanker is
also activated, providing increased noise filtration.
When switched to OFF mode all noise filtration will be
turned off.
RF Gain Control
The RF Gain is used to optimize reception in strong or
weak signal areas.
Note
The RF noise blanker is very
effective in reducing repetitive
noises such as ignition
interference.
Rotate the RF Gain knob counterclockwise to reduce gain
in strong signal areas. In weak signal areas turn clockwise
to increase gain.
NB-ANL/OFF (Noise Blanker/Automatic
Noise Limiter) Button
SIG
RF
+30dB
1
1.5
2
3
CAL
3
5
7
9
SWR
TX
RX
NB/ANL
MEM WX !
ANL
S/RF
NB/ANL
S/RF
SWR/CAL
ESC
MEM SCAN
SCAN CH 9/19
DIM
CB/WX
M
E
N
U
P
U
S
H
E
N
T
E
R
VOL
DYNAMIKE
RF GAIN
DELTA TUNE
T BACK
SWR
CAL
OFF MIN
MIN OFFMAX
SQ
Pressing the Scan/Memory Scan button toggles from
Off to Scan All Channels to Memory Channel Only
Scan and back to Off.
Press the Dim/Escape button to end Scan and
return to CB mode.
1
SIG
RF
+30dB
1
1.5
2
3
CAL
3
5
7
9
SWR
TX
RX
NB/ANL
MEM
ANL
S/RF
SWR
CAL
NB/ANL
S/RF
SWR/CAL
ESC
MEM SCAN
SCAN CH 9/19
DIM
CB/WX
M
E
N
U
P
U
S
H
E
N
T
E
R
VOL
DYNAMIKE
RF GAIN
DELTA TUNE
T BACK
SWR
CAL
OFF MIN
MIN OFFMAX
SQ
Note
If more than 10 channels are
attempted to be programmed,
3 error beeps will be heard and
“Memory Full” will be displayed
for 10 seconds or until any
button is pushed.
2
SIG
RF
+30dB
1
1.5
2
3
CAL
3
5
7
9
SWR
TX
RX
NB/ANL
MEM WX !
ANL
S/RF
SWR
CAL
NB/ANL
S/RF
SWR/CAL
ESC
MEM SCAN
SCAN CH 9/19
DIM
CB/WX
M
E
N
U
P
U
S
H
E
N
T
E
R
VOL
DYNAMIKE
RF GAIN
DELTA TUNE
T BACK
SWR
CAL
OFF MIN
MIN OFFMAX
SQ
Note
The radio should be
squelched before scan
features are activated.
Note
Keying the microphone will stop
the scan feature.
Set first channel. Press and hold the Scan/MemScan
button. The Memory icon will appear. Select a second
channel, press and hold the Scan/MemScan button again
until the Memory icon appears. Repeat above steps to
enter up to 10 channels in memory.
Program Memory Channels
SIG
RF
+30dB
1
1.5
2
3
CAL
3
5
7
9
SWR
TX
RX
NB/ANL
MEM
ANL
S/RF
SWR
CAL
NB/ANL
S/RF
SWR/CAL
ESC
MEM SCAN
SCAN CH 9/19
DIM
CB/WX
M
E
N
U
P
U
S
H
E
N
T
E
R
VOL DYNAMIKERF GAIN DELTA TUNE
T BACK
SWR
CAL
OFF MIN
MIN OFFMAX
SQ
Note
To remove a channel from
memory, go to the unwanted
memory channel then press and
hold the SCAN/MEM SCAN
button until the MEM icon
turns off.
SIG
RF
+30dB
1
1.5
2
3
CAL
3
5
7
9
SWR
TX
RX
NB/ANL
MEM WX !
ANL
S/RF
SWR
CAL
NB/ANL
S/RF
SWR/CAL
ESC
MEM SCAN
SCAN CH 9/19
DIM
CB/WX
M
E
N
U
P
U
S
H
E
N
T
E
R
VOL
DYNAMIKE
RF GAIN
DELTA TUNE
T BACK
SWR
CAL
OFF MIN
MIN
OFF
MAX
SQ
Setting Delta Tune
Rotate the Delta Tune knob to the center position for
optimum tuning.
29LX_MAX_MANL.indd 32-33 10/27/16 4:02 PM

Cobra 29 LX MAX Specifications

General

Type	CB Radio
Frequency Range	26.965 MHz to 27.405 MHz
Channels	40
Power Output	4 Watts
Display	Multi-color LCD
Bluetooth Connectivity	Yes
NOAA Weather Channels	Yes
RF Gain	Yes
Instant Channel 9 and 19	Yes
Weather Scan	Yes
Rewind-Say-Again	Yes
Antenna Impedance	50 Ohms
Voltage	13.8 V DC
Features	Bluetooth, NOAA Weather, Rewind-Say-Again