Coby DVD968 - Channel Delay; Equalizer

www.cobyusa.com Page 39
English
System Setup
LPCM Out
When the DIGITAL OUTPUT option is set to SPDIF/PCM, this item is avail-
able.
Select a sample rating for the analog audio output. There are two op-
tions, KHz and KHz.
Use the standard 48 KHz option unless your amplier/receiver
can support a sample rate of 96 KHz over a coaxial digital con-
nection.
Channel Delay
Set the delay time for the center, rear speakers and the subwoofer.
You may need to set a delay to compensate for the dierence in audio
propagation times caused by the distance of the speakers to the listener.
Use the navigation keys <UP> or <DOWN> to select a speaker,
then use the navigation keys <LEFT> or <RIGHT> to adjust the
distance differential.
This unit does not support delays for when the distance between
the center or surround speakers and the listener are greater than
that between the front speakers and the listener.
In case the channel delay settings cannot match your speaker
conguration, please set all distances to 0cm. If possible, use
your receiver/amplier to set the channel delay.
Equalizer
Sound Mode
Select a sound mode in this item.