8. Finishing Techniques
8.1 Useful Tools/Equipment
• Safety Goggles
• Mask
• Long-nose Pliers
• Wire cutters
• Sandpaper (100,200,300,400,500,600 Grit)
• Medium, ne and extra ne sanding sponges
• Acrylic based primer spray paint
• Acrylic based spray paint (colour of your choice)
• Acrylic based varnish spray paint
NOTE: Dierent paint types are also compatible with PLA and ABS. Consult your local paint supplier for
the best compatibility for your intended purpose.
8.2 Removing Support Material
Even after support material is removed by hand, residual material will remain.
1. Ensure that safety goggles and a mask are worn for protection
2. Remove most of the support material by hand, taking care not to
damage the 3D object
3. Using the long-nose pliers, carefully grasp some of the remaining
material, then twist to remove. Repeat until no more material can be
removed.
4. Using the wire cutters, cut away any excess lament.
3
Finishing
To Next Page
Loading...