Setting up and operating the BUC system
62 Block Up Converter Systems 6700/6900 series User Guide
Serial interface monitor and control
To view or change the operating parameters of the BUC, the
BUC must be connected to a terminal (for example, a Hand-
held Controller 6560, a Remote Controller 6570, a PC, or an
organiser emulating a terminal).
To establish communications between the PC and the BUC see
page 39, Connecting the serial interface.
For more advanced remote control applications, contact your
Codan representative.
The BUC is monitored and controlled using 3-letter operating
commands followed, in some cases, by data. These commands
are described in Table 13 to Table 17.
NOTE
The commands listed in Table 13 to Table 17
are used with common installations. If you have
other requirements for your installation, contact
your Codan representative for the facilities and
commands available.
To Next Page
Loading...
