Code Blue CB 1 Series - Blank Ring Installation Instructions; General Installation for Blank Rings; Required Tools for Ring Installation; Blank Ring Installation Steps

Code Blue
•
259 Hedcor Street
•
Holland, MI 49423 USA
•
800.205.7186
•
www.codeblue.com
GU-157-AApage 56 of 76
CB 1 Series
Administrator Guide
29 Blank Ring Installation Instructions
Code Blue has blank Mounting Rings available as optional features for its 1 Series Pedestal Help
Points
®
(CB 1-w not included). Designed in three varieties, these rings allow a customer to internally
and externally mount third party communication and security equipment to their unit to enhance con-
nectivity and functionality.
INSTALLATION:
All Rings: CB 1-e and CB 1-s (including Public Address and AED Housing Options)
TOOLS REQUIRED:
• Allen wrenches • Security bit • Ladder (if retrotting) • Mounting Ring with screws
INSTRUCTIONS:
• If applicable, remove dome top assembly using security bit prior to installation. New style
dome top assembly (part #40259) is required to access installation screws on Mounting
Ring. Locate and install the three ½ x 1-inch hex Allen screws from the inside of the Mount
ing Ring using the Allen wrench. Be sure the Allen screws do not extend beyond the outside
of the ring.
• Install the mounting ring on top of the unit. Rotate to desired position.
o NOTE: If retrotting existing unit with three countersunk holes near the top of the
unit, the Mounting Ring may be rotated to align the clearance holes with holes in
the unit. The three countersunk screws and nuts provided may be used to cover
these holes. The three Allen screws MUST be used to secure the mounting ring
to the unit.
o NOTE: If installed on a unit with an Overhead Camera Mount, the Mounting Ring
should be mounted on top of the Overhead Camera Mount ring.
• Verify Mounting Ring is evenly positioned to ensure gasket seal is seated appropriately 360
degrees.
• Apply downward pressure while simultaneously tightening the three ½-inch set screws until
Mounting Ring is snug against the inside of the unit.
• Install Beacon/Strobe Dome Top Assembly.
POWER:
• The 1 Series power conguration is only intended to support the electronics Code Blue
installs as standard equipment.
*IF A CUSTOMER INSTALLS THEIR OWN POWER SOURCE, IT WILL VOID THE ENCLOSURE’S
UL LISTING.
Please contact Customer Service with any questions or concerns.
Email: customerservice@codeblue.com
Phone: 616-392-8396, Opt. 2