Code Blue
•
259 Hedcor Street
•
Holland, MI 49423 USA
•
800.205.7186
•
www.codeblue.com
GU-149-AApage 22 of 63
CB 2 Series
Administrator Guide
Strip all wires and twist tight.
Place small screwdriver into square hole and push down. Insert cut wire into
round hole and remove screwdriver. Repeat on the rest of the connectors.
Once all connectors have been switched, you are ready to apply power to the
LED.
This will work on strobe, area and faceplate lights.
Please contact technicalsupport@codeblue.com if you need further assistance.
To Next Page
Loading...
