Code Blue IA4100 - Page 26

page 26 of 45 GU-139-Z1
Call the extension or phone number of CB Unit, after the RFA tone:
(Continued on next page)
Programming Commands (continued)
Programming Outputs
Programming Recordings
NOTES: Active Time Values
00 = disabled
01 - 60 = 1 to 60 seconds
61 - 90 = 1 minute to 30 minutes
91 = until the end of the call
92 = until trigger on input 2
NOTES:
RECORDING STEPS
1. Enter Command 21-29 followed by the # key
2. Wait for the beep
3. Recite your message
4. Enter # to confirm completion
5. The message will be played back for approval
6. Repeat steps 1-4 if your message is not acceptable
7. Enter the # key to terminate playback (21-29 Programming Mode only).
Maximum message length is 30 seconds.
To listen to a recorded message, dial ** <Command 21-29>#
For example: To listen to recording number 4 (Command 24): ** 24#
Message volume level can be changed with programming Command 67.
Command
Command Explanation
Explanation
Format
Format Default
11
12
13
12583#
21
22
23
24
25
26
27
28
29
*#
Auxiliary output 1
Auxiliary output 2
Auxiliary output 3
Message recording #1
Message recording #2
Message recording #3
Message recording #4
Message recording #5
Message recording #6
Message recording #7
Message recording #8
Message recording #9
11<active time>#
12<active time>#
13<active time>#
programming mode
21<record message>#
22<record message>#
23<record message>#
24<record message>#
25<record message>#
26<record message>#
27<record message>#
28<record message>#
29<record message>#
hang up and exit programming
91
01
01
Recording Messages
IA4100
Administrator Guide
Code Blue
• 259 Hedcor Street • Holland, MI 49423 USA • 800.205.7186 • www.codeblue.com