Code Reader 1000 - Using the CR1000 Scanner; Using the CR1000 Out of Stand; Using the CR1000 in Stand

C005905_04_CR1000_User_Manual
4.0 - Using a CR1000 Out of a Universal Stand
5.0 - Using a CR1000 in a Universal Stand
Revision 3 Hardware of the CR1000 has a stand detecon feature. By default, when the
CR1000 is placed in the stand, the reader will enter into moon detecon mode. When
in this mode, simply place a bar code in the scan eld to acvate the reader. The CR1000
will beep and ash a green LED to indicate a ‘good read’ has occurred.
When the CR1000 is removed from the stand, the reader switches to manual mode and
the buon must be pressed to read a bar code (refer to Secon 4.0).
Revisions 1 and 2 Hardware of the CR1000 do not have a stand detecon feature
to enable moon detecon reading when the CR1000 is in a stand. To congure
these hardware revisions for moon detecon scanning, please refer to the CR1000
Conguraon Guide, located at www.codecorp.com/les.php and scan the appropriate
code.
2
See Secon 10.0 to learn how to determine your CR1000
hardware revision number.
Press and hold the buon on the top of the CR1000, the two blue bars eming from the
reader are used for targeng. Center the blue bars in the middle of a bar code. The opmal
reading distance from reader to bar code is approximately 4.0” (10 cm).
Once the reader is at the opmal distance, the reader will read the bar code. The CR1000 will
beep and ash a green LED to indicate a ‘good read’ has occurred.
To modify any default sengs, download the CR1000 Conguraon Guide at
www.codecorp.com/les.php and scan the appropriate code.