Connect the Ethernet Cable
1. Connect the Ethernet cable M12 connector to the vision sensor Ethernet
connector.
2. Connect the Ethernet cable RJ-45 connector to a switch/router, as
applicable.
Connect the Breakout Cable
Note: Unused wires can be clipped short or tied back using a tie made of non-
conductive material. Keep all bare wires separated from the +24VDC wire.
1. Verify that the 24VDC power supply being used is unplugged and not
receiving power.
2. Optionally, connect the I/O or serial wires to an appropriate device (for
example, a PLC).
3. Attach the Breakout cable +24VDC (red wire) and GROUND (black wire) to
the corresponding terminals on the power supply.
CAUTION: Never connect voltages other than 24VDC. Always
observe the polarity shown.
4. Attach the Breakout cable M12 connector to vision sensor Power and I/O
connector.
5. Restore power to the 24VDC power supply and turn it on if necessary.
11
To Next Page