Cognex AS200 - Configure Sensor Settings

5.
To accept the changes, click . To cancel, click .
6. The Available Cameras tab displays the camera.
Configure a Sensor
Once you discover a camera, you can configure a sensor by completing the following
steps:
1. On the Settings tab, type sensor name in the Name text box.
2. On the Available Cameras tab, ensure that the selected camera is
highlighted.
3.
To move the camera to the Settings tab, click .
4. On the Settings tab, ensure that the Master check box is selected.
5. Configure the PLC/Robot Communication settings.
If you use the TCP/IP protocol, select TCP/IP and configure the Port
Number PLC/Robot setting.
If you use the SLMP Scanner protocol, select SLMPScanner and
configure the PLC settings.
Note: For more information about the PLC/Robot Communication
settings, see the AS200 Alignment Sensor User Guide.
6.
Click . You have configured the sensor.
25