1. Verify that the 24 V DC power supply is unplugged and not receiving
power.
2. Attach the +24 V DC connector of the Power and I/O Breakout cable and
Ground wires to the corresponding terminals on the power supply. For
more information, see Specifications on page36.
CAUTION: Never connect voltages other than 24 V DC. Always
observe the polarity shown.
3. Attach the M12 connector of the Power and I/O Breakout Cable to the 24 V
DC connector of the reader.
4. Restore power to the 24 V DC power supply and turn it on if necessary.
Using your Device through USB
For a detailed description, see the DataMan 280 Reference Manual.
35
To Next Page
Loading...
