To Next Page
M
Mark DeckerJul 29, 2025
What to do if Cognex Barcode Reader is not detected in Setup Tool?
- DDorothy FosterJul 29, 2025
If the Cognex Barcode Reader isn't showing up in the Setup Tool's list of network devices, start by verifying the Ethernet connection to the reader and then click 'Refresh' in the Setup Tool. If it still doesn't appear, scan the Enable DHCP code from the DM200 Configuration Codes document. If problems persist, use the 'Add Device' option if you know the IP address, or the 'Force Network Settings' option if you don't.
General
