1.12 Care and Maintenance
FILTRATION SYSTEM
COLDTUB™s are equipped with balanced ltration, meaning that the lter cartridges are sized to meet
the needs of the pump system. As with any water ltering system, the lter cartridge may become clogged,
resulting in reduced water ow. It is important to maintain a clean, unobstructed lter system. We recommend
replacing your lter regularly depending on usage.
FILTER CARTRIDGE REMOVAL AND INSTALLATION
1. Shut the tub down using the on/off button on the topside control panel. Wait until all pumps have stopped
completely (this may take up to 3 minutes).
2. Remove the lter basket.
3. Remove the lter cartridge.
4. Clean any debris out of the skimmer basket.
5. To reinstall the new lter cartridge, reverse the order of steps in which it was removed.
CARE OF THE SHELL
Your COLDTUB™ has a reinforced, cast acrylic shell. Stains and dirt generally will not adhere to your tub’s
surface. A soft cloth or sponge should easily remove most dirt. Most household chemicals are harmful to your
tub’s shell, do not use them. Baking soda or vinegar can also be used for minor surface cleaning. Always
thoroughly rinse off any tub shell cleaning agent with fresh water.
SERVICE NOTE:
The use of alcohol or any household cleaners other than those listed to clean the shell surface is NOT
recommended. DO NOT use any cleaning products containing abrasives or solvents since they may damage
the shell surface. Damage to the shell by the use of harsh chemicals in not covered under the warranty.
IMPORTANT!
The use of
clariers and foam
inhibitors is not
recommended with
disposable lters!
(Continued)
13
To Next Page
Loading...