LED LIGHT REPLACEMENT
ALL COLDTUB™S COME EQUIPPED WITH A BLUE LED (LIGHT EMITTING DIODE) LIGHT
FOR NIGHT-TIME USE. THE OPTIONAL UPGRADE LIGHT COMES WITH A MULTI
COLOURED LED. SHOULD YOU WISH TO CHANGE EITHER LIGHT, FOLLOW THESE
SIMPLE STEPS:
1. Make sure the light is turned off, by checking the topside to see if the light icon is not showing.
2. Remove the screws securing the equipment access doors; remove the doors.
3. Locate the lamp assembly, which is secured into the light housing. Carefully rotate the lamp assembly
counter-clockwise until it comes off the light housing.
4. Remove the LED assembly from the socket and replace with a new assembly. Contact tech support for part
number. Reconnect the cable(s).
NOTE: TAKE CARE TO INSERT THE PLUG IN THE CORRECT ORIENTATION, OR YOU MAY
DAMAGE THE CONNECTORS.
5. To reinstall, rotate the lamp assembly clockwise onto the light housing until secure.
VACATION CARE INSTRUCTIONS
If you plan to be away for 7 - 14 days, follow these instructions to ensure that the water quality of
your tub is maintained.
1. Adjust pH as needed.
2. Ensure you have sufcient sanitizer to last until you return.
3. Shock the tub with a tablespoon of Cold Water Sanitizer and oxidizer.
4. Lower the temperature to between 45ºF and 55º F.
UPON YOUR RETURN
1. Shock the tub with a tablespoon of Cold Water Sanitizer and oxidizer.
2. Ensure you have sufcient sanitizer for regular use.
3. Return the temperature to its original setting. You can use your tub once the residual sanitizer level falls
within the ideal range.
WINTERIZING
If you plan to leave your tub unused in severely cold weather, you should drain the tub and add RV antifreeze
to avoid accidental freezing. For assistance contact tech support. Damage due to freezing is not covered
under and can void warranty.
TO RESTART TUB
Reinstall the lter cartridges; close the drain valve. Follow the Start-up and Rell procedures.
1.12 Care and Maintenance
(Continued)
14
To Next Page
Loading...