CARE OF THE COVER
ATTENTION: The cover is a manual safety cover that meets or exceeds all prevailing requirements of ASTM
Standards for safety covers when installed and used correctly as of the date of manufacture. Non-secured or
improperly secured covers are a hazard. Always open the cover to its fully open position before use. Be sure
to inspect the cover for premature wear or deterioration. Over time, with use, there is a chance of normal cover
wear and deterioration. To properly maintain your cover see directions below.
VINYL COVER
The vinyl tub cover is an attractive, durable foam insulation product. Monthly cleaning and conditioning are
recommended to maintain its beauty.
To clean and condition the vinyl cover:
1. Remove the cover from the tub and gently lean it against a wall.
2. With a garden hose, spray the cover to loosen and rinse away dirt or debris.
3. Using a large sponge and/or a soft bristle brush, and a very mild soap solution or baking soda, scrub the
vinyl top in a circular motion. Do not let the vinyl dry with a soap lm on it before it can be rinsed clean.
4. Scrub the cover’s perimeter and side aps. Rinse clean with water.
5. Rinse off the underside of the cover with water only (use no soap), and wipe it clean with a dry rag.
1.13 Manual Safety Cover
15
To Next Page
Loading...