COLDTUB Icekube - Page 25

WWW.COLDTUB.COM
A. Dirty lter, increase Filter cycle.
B. Add Cold Water Clear ( not with disposable lter )
C. Shock treatment with Cold Water Oxidizer.
D. Add Cold Water Run Down to adjust TA level to 100-130 ppm.
E. Add Cold Water Run Down until PH level reads 7.2-7.6.
F. Cold Water Oxidizer treatment until combined chlorine is eliminated
(see container instructions).
G. Empty tub and rell.
A. pH has gone to high. Empty tub and rell.
B. Add Cold Water Sanitizer treatment to raise chlorine levels and test chlorine levels.
C. Stop the use of fragrance.
Cold Water Bubble Remover on foam. (not with disposable lter)
Empty tub,clean,rell and correct Alkalinity to 80-130ppm then pH to 7.2 - 7.6
A. Add sanitizers until levels are up to the recommended levels.
B. Replace test kits at least once a year.
C. Chlorine level very high and is bleaching test reagent, Allow sanitizer levels to recede by
opening cover and running jets.
A. High concentration of contaminants using up sanitizers.
B. Test kit reagents ine󰀨ective.
A. Check pH and adjust as required.
B. Shock with Oxidizer, add Sanitizer
C. Dilution of water will reduce contaminants and odor.
D. Check if ozone system is operational.
SOLUTIONS
23