1.7 Electrical Installation Instructions
COLDTUB™ MUST BE WIRED IN ACCORDANCE WITH ALL
APPLICABLE LOCAL ELECTRICAL CODES. ALL ELECTRICAL
WORK SHOULD BE DONE BY AN EXPERIENCED, LICENSED
ELECTRICIAN AND APPROVED BY A LOCAL BUILDING/ELEC-
TRICAL INSPECTION AUTHORITY. WE RECOMMEND THE
USE OF APPROPRIATE ELECTRICAL CONDUIT, FITTINGS
AND WIRE FOR ALL CIRCUITS.
WARNING: Removing or bypassing any Ground Fault Circuit In-
terrupter breaker will result in an unsafe tub and will void the tub’s
warranty.
WARNING!
All electrical
hookups ( except
where cords with
built in GFCI
are supplied by
COLDTUB™ must
be performed by a
licensed electrition!
WARNING!
Do not turn on power to the
tub until the tub is lled to the
required level. Running the
pump without water could
cause immediate damage and
void your warranty!
IMPORTANT: Should you ever nd the need to relocate your COLDTUB™, it is
essential that you understand and apply these installation requirements. Your Cold-
Tub has been carefully engineered to provide maximum safety against electric shock.
Remember, connecting the tub to an improperly wired circuit will negate many of its
safety features.
1.6 Equipment Compartment and
Wiring Diagram
5
To Next Page
Loading...