Control Systems
Powerworks™ 460 Series Control System
The Powerworks™ 460 Series Control System offers you
the ultimate in spa control. The backlit, Liquid Crystal
Display (LCD) displays current water temperature, set
point water temperature, time, and operating mode set-
tings. Each feature of the system is actuated through a
control panel touch pad. Touch the appropriate pad to acti-
vate the desired function.
At start up, when power is supplied to the spa, the con-
trols will operate properly and safely under the factory set-
tings. The spa will be in
Standard Mode, have a temper-
ature setting of 100°F, and a filtration cycle duration of 2
hours. To fully utilize the unique capabilities of the control
system, it is important to know how to set the temperature,
operate the pumps, operate the light, adjust the mode set-
ting, and change the filtration cycles.
Note: In event of a power outage or failure, the 460
Series Control System should retain all settings, except
time of day. If settings are lost, re-program per the instruc-
tions in this manual and contact your dealer.
User’s Pads
User’s Pads are the buttons located on the topside con-
trol panel and are used to program various spa func-
tions (i.e., turn on spa light, set temperature, etc.). The
following table defines the pads:
12
To Next Page
Loading...
Need help?
General
