EasyManuals Logo

Colnago TT1 Assembly Instructions

Default Icon
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
Once the hoses are inside the frame,
fork and basebar, run the electric
wires according to the instruction
in the section ‘Electric wire routing’.
Following the specic manufacturer
instructions, connect wires and
hoses to the levers and install them
on the basebar.
Adjust the hose lengths cutting the
exceeding parts from the caliper ends.
Complete the brake mounting
and adjustment following the
manufacturer instructions.
4
5
6
7
(img 8)
(img 9) (img 10)
17
16
Electric wire routing
Colnago recommends installing electric cables and junction points after brake hose. The presented routing schematics are
intended as a supplement to the groupset manufacturers’ installation. For any more detailed information, please refer to the
manufacturers’ technical manual, website, or service center.
Figure 9: Shimano Di2 frame wire routing Figure 10: Campagnolo frame wire routing
Elettr. Interface cover N26 to
be replaced with the battery.

Other manuals for Colnago TT1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Colnago TT1 and is the answer not in the manual?

Colnago TT1 Specifications

General IconGeneral
GroupsetShimano Dura-Ace Di2
Wheel Size700c
BrakesShimano Dura-Ace
StemColnago
SaddlePrologo

Related product manuals