7
6
List of Recommended Tools and Supplies
The following tools and parts listed are required for mounting and adjusting procedures of Colnago parts. Colnago recommends
any intervention on the bike to be performed by an authorized Colnago retailer.
Refer to each specic mounting procedure and requirements for the assembly of a specic component, provided its own manufacturer.
NOTE: If you are a Colnago TT1 consumer/purchaser reading this manual, we suggest you consult your authorized Colnago
retailer before undertaking any procedure in this manual.
Professional cycle
work stand
Hydraulic bleed kit
Pedal wrench
Open ended wrenches;
7-8-10-17mm
High quality grease
& carbon assembly
compound for bikes
Brake rotor lockring
tools (inner and outer)
Allen hex key:
2, 2.5, 3, 4, 5, 6, 8, 10, 12 mm
Hacksaw
(with carbon blades)
Cable cutters
2.5-15Nm Torque
wrenches tool
Saw cutting guide
Pliers
Phillips and slot-
head screwdriver
Isopropyl alcohol
Di 2 wire tool -
Shimano
To Next Page
Loading...
Need help?
General
