• Connect the Treadmill Stimulus Detection to the same source of AC power as the Treadmill Controller.
To Connect the Treadmill Stimulus Detection to the Modular Treadmill:
• Using a detection cable, connect the “Detection” port of the Treadmill Stimulus Detection to the 25-
pin male D-SUB port on the back of the treadmill lane most close to the motor assembly. Physically,
this lane will be channel 1.
(other cables removed for clarity)
• Using additional detection cables, connect the free 25-pin male D-SUB port from channel 1 to the next
lane, using the port most close to lane 1. Physically, this will be channel 2. Repeat this procedure for
additional lanes.
(other cables removed for clarity)
To Next Page
Loading...
