30
On consignment of the machine
When the machine is consigned to the customer, an immediate check
must be performed to ensure all the material mentioned in the
shipping documents have been received and moreover to find out that
the machine has not suffered damage during transportation. If damage
has occurred, get the shipping agent to verify immediately the amount
and nature of the damage suffered and at the same time inform our
claim department. It is only by prompt action of this type that
compensation for damage may be successfully claimed.
Introductory comment
This is a floor cleaning machine which, using the mechanic abrasive
action of two rotary brushes and the chemical action of a solution
water-detergent, is able to clean any type of floor, picking up during
its advance movement, the removed dirt and the detergent solution
which has not been absorbed from the floor.
The machine must be used only for such purpose. We would impress
upon you that any machine will function efficiently and operate
successfully, only if used correctly and maintained in fully efficient
working order. We therefore suggest you to read this instruction
booklet carefully and re-read it whenever difficulties arise in the
course of machine use. Our Service Department is at your disposal for
all such advice and servicing as may prove necessary.
TECHNICAL DATA C85B C100B
Cleaning width mm 830 1000
Base side movement mm 150 150
Squeegee width mm 1110 1230
Working capacity sqm/h 5400 6500
Brushes ∅ mm 430 510
Brushes rpm rpm 180 180
Brushes pressure kg 130max 150max
Brushes motor W 1500 2000
Traction motor W 1300 1500
Traction wheel ∅ mm 300 300
Movement speed km/h 0÷6.5 0÷6.5
Max. gradient under full load 10% 10%
Suction motor W 670 670
Suction vacuum mbar 190 190
Rear elastic wheels ∅ mm 300x90 370x105
Solution tank l 170 265
Recovery tank l 190 280
Steering diameter mm 2500 2800
Machine length mm 1920 2040
Machine height mm 1410 1900
Machine width mm 870 1120
Measurements battery compartment (width x length x height) mm 540x740x525 600x890x450
Batteries’ tension V36 36
Batteries Ah in 5 h 420max 480max
Batteries weight kg 420max 500max
Machine weight (empty and without batteries) kg 450 585
Acoustic pressure level (in conformity with EN ISO 11201) dB (A) 69.6 73.1
Vibration level to the hand m/sqs 2.1 1.56
Vibration level to the body m/sqs 1.05 0.98
To Next Page
Loading...
