COMAC SIMPLA 50 BT - User Manual

Questions and Answers

K
Kathryn Reyes DDSAug 8, 2025
Why is the COMAC SIMPLA 50 BT squeegee not drying perfectly?
- S
  Sandra SmithAug 8, 2025
  If the COMAC Scrubber's squeegee isn't drying properly, several factors could be at play. First, ensure the squeegee rubbers are clean. Then, verify that the suction tube is correctly inserted into its housing on the recovery tank. Also, check that the inner filter of the recovery tank isn't dirty; clean it thoroughly if needed. Finally, consider adjusting the inclination and height of the squeegee.
R
ronald28Aug 15, 2025
How to fix insufficient water on the brush of COMAC SIMPLA 50 BT Scrubber?
- A
  alvarezmargaretAug 15, 2025
  If there's insufficient water on the brush of your COMAC Scrubber, start by checking that the solution filter isn't blocked. Next, ensure the tap beneath the symbol is turned on. Finally, confirm that there's water in the solution tank.
H
hamiltontylerAug 20, 2025
What to do if COMAC SIMPLA 50 BT does not clean well?
- D
  Debra MacdonaldAug 21, 2025
  If your COMAC Scrubber isn't cleaning well, check the condition of the brush for wear and tear; replace it if the bristles are about 15 mm long. You might also consider using a specialized brush designed for particularly resistant dirt, available upon request.
M
Michael SmithAug 26, 2025
Why is COMAC SIMPLA 50 BT producing excessive foam?
- R
  Robin RothAug 26, 2025
  If your COMAC Scrubber is producing excessive foam, first verify that you're using a low-foam detergent. If the issue persists, try adding a small amount of antifoam liquid to the recovery tank. Remember that when the floor isn't very dirty, more foam can be generated, so the detergent solution should be more diluted in such cases.
L
Lauren HernandezSep 1, 2025
What to do if electric fuses and thermal cut-outs are triggered in COMAC SIMPLA 50 BT?
- J
  joshuathompsonSep 1, 2025
  In the event of malfunctioning with the COMAC Scrubber, check if a thermal cut-out has intervened. If the motor overheats, its thermal cut-out will block the electricity supply. Wait a few minutes for it to cool down, then press the specific circuit breaker button to reactivate the power supply and motor operation.