10
MACHINE PREPARATION
4. Pull the brake lever (3) and block the machine using the pin (4).
4. BATTERY FITTING/CONNECTION (FOR B-BT VERSIONS ONLY)
The machine may be supplied with batteries and a built-in battery charger.
When using batteries other than those supplied with the machine, have the configuration of the battery
charger and the control board verified by an engineer certified and trained by the COMAC service
centre.
Perform a battery charging cycle before using the machine.
The batteries must be housed in the special compartment beneath the recovery tank.
To insert the batteries you must:
1. Lower the squeegee and base (see the appropriate chapter)
2. release the hinges (1) on the handlebars
3. Check the recovery tank is empty, otherwise empty it (see the appropriate chapter).
4. Rotate the tank as far as it will go, using the side handle (2)
5. Lift the batteries by means of the grips on the upper part
6. house the batteries in the compartment, positioning the poles “+” and “-“ opposite each other
7. connect the batteries in series - using the jumper cables supplied (3) - to the poles “+” and “-“
8. connect the battery connector cable (4) to the terminal poles “+” and “-“ to obtain a voltage of 24V
on the clamps
ATTENTION: you are advised to use airtight batteries only, to avoid the
leakage of acids!
ATTENTION: you are advised to have the electric connections made by a
qualified, COMAC-trained technician
ATTENTION: you are advised to always wear protective gloves, to avoid the
risk of serious injury to your hands
ATTENTION: you are advised to only lift and move the batteries with lifting
and transportation means suitable for the specific weight and size
ATTENTION: Connect the traction motor connector before fitting the batteries.
this process must be carried out by qualified personnel. An incorrect
connection of the connector may cause problems with machine functioning.
This operation is possible for machines with traction only
1
2
3
4
3
4
To Next Page
Loading...
