24
DAILY MAINTENANCE
4. DISASSEMBLING AND CLEANING THE SQUEEGEE
Check the squeegee is always clean, for better drying results.
To clean it you must:
1. Turn main switch key anticlockwise to position "0", and remove the key, for the electric versions
unplug the machine from the mains, and engage the parking brake.
2. remove the tube (1) from the squeegee
3. remove the squeegee, pushing the plate (2) to the left in order to release the squeegee small column
from its seat
4. pull the squeegee to the right until the left-hand small column is released from its seat
5. carefully clean the inside of the squeegee and its suction nozzle
6. carefully clean the squeegee rubbers
7. reassemble all the elements
5. DISASSEMBLING THE BRUSH
1. Turn the key of the main switch anticlockwise to position "0", and remove the key, for the electric
versions unplug the machine from the mains, and engage the parking brake.
2. Raise the base, using the lever
3. With the base up, rotate the brush counter-clockwise until it comes out of the brush-holder plate seat,
as shown in the figure.
4. Always check the bristles for signs of wear. You are advised to replace the brushes when the bristles
are less than 15 mm long
WARNING: you are advised to always wear protective gloves in order to avoid
the risk of serious injury to your hands
1
2
To Next Page
Loading...
