Need help?Do you have a question about the COMAC OMNIA 32 and is the answer not in the manual?
How to handle the machine package safely and correctly during transport.
Steps for safely removing the machine from its packaging and pallet.
Procedure for connecting the traction motor cable, performed by a technician.
Guidance for installing batteries into the machine compartment safely.
Instructions for connecting the battery connector to the machine.
How to connect the battery charger to the machine's battery system.
Procedure and precautions for recharging the machine's batteries.
Explanation of the digital indicator for battery charge levels.
Instructions for assembling the floor-wiper (squeegee) onto the machine.
How to adjust the squeegee's rear rubber for optimal drying performance.
Steps for assembling the brush base covers specific to the Omnia 42 model.
Detailed steps for installing the rotating brushes onto the machine base.
Checks and procedures related to the solution and recovery tanks.
Instructions for filling the solution tank with water and detergent.
Controls for automatic and manual operation of the squeegee and suction motor.
How to manually adjust the pressure applied by the brushes to the floor.
Adjusting brush pressure on machines with automatic actuator control.
Information on the machine's electronic traction control and speed variation.
Details on the machine's working, parking, and emergency brake systems.
Explanation of the float device that signals a full recovery tank.
Guidelines for using the optional cleaning solution recycling system.
Procedure for emptying and cleaning the machine's recovery tank.
Steps for removing, cleaning, and reassembling the recovery tank filter.
Instructions for cleaning the filter located in the solution tank.
How to clean the squeegee and its rubber parts for optimal drying.
Procedure for removing the rotating brushes from the machine.
Steps to replace the worn rear rubber edge of the squeegee.
Procedure for replacing the front floor-wiper rubber.
How to check and replace the splash guard rubbers on the brush base.
Diagnosing and resolving issues with low water supply to the brushes.
Troubleshooting steps for when the machine is not cleaning effectively.
Solutions for problems where the squeegee leaves the floor wet.
Steps to identify and fix issues with the suction motor not operating.
Addressing problems caused by too much foam during operation.
To Next Page
General
