How to troubleshoot a COMAC OPTIMA 100 Scrubber that won't start?
If your COMAC Scrubber doesn't start, ensure the main switch is set to 'I'. If the problem persists, stop the machine immediately and contact a specialized service center. Also, check the battery charge level and perform a complete recharge cycle if it's critically low.
Why is my COMAC OPTIMA 100 Scrubber squeegee not drying properly?
If the squeegee on your COMAC Scrubber isn't drying perfectly, the vacuum unit might be obstructed. Ensure the squeegee is free of obstructions. Also, check that the cap on the recovery tank drainage tube and the recovery tank lid are positioned properly.
What to do if my COMAC OPTIMA 100 does not vacuum correctly?
If your COMAC Scrubber isn't vacuuming correctly, the recovery tank might be full. Empty the recovery tank. Also, check the squeegee.
Why are the batteries on my COMAC OPTIMA 100 not charging correctly?
If the batteries on your COMAC Scrubber aren't charging correctly, stop the machine immediately and contact a specialized service center. Check that the battery charger power supply cable plug is connected to the mains socket and that the characteristics in the battery charger plate are the same as those of the mains supply. Also, check the meaning of the flashing signals that the battery charger emits during the battery recharge stage, referring to the battery charger use and maintenance manual.
What to do if COMAC OPTIMA 100 Scrubber does not clean correctly?
If your COMAC Scrubber isn't cleaning correctly, check if the machine starts. Also, check the detergent solution on the brushes, ensure the brushes have been correctly inserted, that they are adequate for the work, and check the condition of the brush and replace it if necessary.
Why is there insufficient detergent solution on the brushes of my COMAC OPTIMA 100?
If there's insufficient detergent solution on the brushes of your COMAC Scrubber, ensure the amount of detergent solution in the machine's water system is sufficient for the work. Also, check if the detergent solution filter is obstructed and clean it if necessary.
How to reduce excessive foam production in my COMAC OPTIMA 100 Scrubber?
To reduce excessive foam production in your COMAC Scrubber, check that a low foam detergent has been used. If necessary, add a small quantity of anti-foam liquid to the recovery tank. You can also try diluting the detergent more.
What to do if COMAC Scrubber does not move?
If your COMAC Scrubber does not move, check if the machine starts. If the machine starts and still does not move, stop the machine immediately and contact a specialized service center.
Safety precautions and procedure for recharging machine batteries.
Procedures and safety measures for safely switching off the machine.
Essential checks and preparations before starting machine operation.
Final steps to secure the machine and perform routine maintenance after use.
Procedure for emptying the machine's recovery tank.
Step-by-step guide to replace the rubber blades on the squeegee body.
Instructions for replacing worn brushes in the brush head.
Detailed steps to adjust squeegee rubber blades for correct floor contact.
General| Model | OPTIMA 100 |
|---|---|
| Category | Scrubber |
| Solution tank capacity | 200 liters |
| Power supply | 36 V |
| Power Source | Battery |
| Voltage | 36 V |
| Working width | 1000 mm |
| Brush Width | 1000 mm |
To Next Page
