How to troubleshoot a COMAC Scrubber that won't start?
If your COMAC Scrubber doesn't start, ensure the main switch is set to 'I'. If the problem persists, stop the machine immediately and contact a specialized service center. Also, check the battery charge level and perform a complete recharge cycle if it's critically low.
Why is my COMAC OPTIMA 85B Scrubber squeegee not drying properly?
If the squeegee on your COMAC Scrubber isn't drying perfectly, the vacuum unit might be obstructed. Ensure the squeegee is free of obstructions. Also, check that the cap on the recovery tank drainage tube and the recovery tank lid are positioned properly.
What to do if my COMAC OPTIMA 85B does not vacuum correctly?
If your COMAC Scrubber isn't vacuuming correctly, the recovery tank might be full. Empty the recovery tank. Also, check the squeegee.
Why are the batteries on my COMAC Scrubber not charging correctly?
If the batteries on your COMAC Scrubber aren't charging correctly, stop the machine immediately and contact a specialized service center. Check that the battery charger power supply cable plug is connected to the mains socket and that the characteristics in the battery charger plate are the same as those of the mains supply. Also, check the meaning of the flashing signals that the battery charger emits during the battery recharge stage, referring to the battery charger use and maintenance manual.
What to do if COMAC Scrubber does not clean correctly?
If your COMAC Scrubber isn't cleaning correctly, check if the machine starts. Also, check the detergent solution on the brushes, ensure the brushes have been correctly inserted, that they are adequate for the work, and check the condition of the brush and replace it if necessary.
Why is there insufficient detergent solution on the brushes of my COMAC Scrubber?
If there's insufficient detergent solution on the brushes of your COMAC Scrubber, ensure the amount of detergent solution in the machine's water system is sufficient for the work. Also, check if the detergent solution filter is obstructed and clean it if necessary.
How to reduce excessive foam production in my COMAC OPTIMA 85B Scrubber?
To reduce excessive foam production in your COMAC Scrubber, check that a low foam detergent has been used. If necessary, add a small quantity of anti-foam liquid to the recovery tank. You can also try diluting the detergent more.
What to do if COMAC OPTIMA 85B does not move?
If your COMAC Scrubber does not move, check if the machine starts. If the machine starts and still does not move, stop the machine immediately and contact a specialized service center.
Essential safety precautions during battery recharging to prevent hazards.
Covers dangers and warnings related to operating the scrubbing machine.
Steps and precautions for safely shutting down and deactivating the machine.
Safety precautions to be observed before and during maintenance operations.
Instructions and warnings for safely transporting the machine.
Identifies symbols present on the machine's command panel.
Explains symbols found on the machine's control panel for various functions.
Outlines essential safety principles and operational regulations for machine use.
Detailed steps and safety precautions for recharging the machine's batteries.
Steps to start the machine after preparation, including display checks and direction selection.
Explains the four main operating modes: Transfer, Drying, Scrubbing with Drying, Scrubbing without Drying.
Procedure for activating the emergency button and its effect on machine functions.
Explains the alarm screen, codes, and meanings for troubleshooting machine issues.
Addresses issues like the machine not starting or battery charging problems.
Solutions for insufficient detergent, incorrect cleaning, and squeegee drying problems.
Troubleshooting for machine movement, foam production, and vacuuming issues.
To Next Page
General
