REGISTRATION PLATE
The serial number plate is located at the rear of the steering column, and indicates the machine's general characteristics, including its serial number. The serial number is a very important piece of information and
should always be provided together with any request for assistance or when purchasing spare parts. The serial number plate contains the following:
1. The weight of the batteries used to power the appliance (expressed in Kg).
2. The IP protection rating of the appliance.
3. The gross weight of the appliance (expressed in Kg).
4. The identication code of the appliance.
5. The serial number of the appliance.
6. The name of the appliance.
7. The nominal power consumed by the appliance (expressed in W).
8. The maximum grade that the appliance can handle during work activities (expressed in %).
9. The year in which the appliance was manufactured.
10. The nominal voltage of the appliance (expressed in V).
11. The commercial name of the appliance and the manufacturer's address.
11
10
9
8
7
6
1
2
3
4
5
TECHNICAL DATA (INTERNATIONAL SYSTEM) U/M
OPTIMA
85B
OPTIMA
100B
Rated power W 2840 2840
Working width mm 850 1010
Squeegee width mm 1120 1120
Work capacity, up to m
2
/h 6800 8080
Number and diameter of the brushes No. / Ø mm 2 / 430 2 / 520
Brushes rpm rpm 160 160
Electrical characteristics of the brush motor V/W 24 / 500 24 / 500
Maximum weight of the brushes kg 63 63
Electrical characteristics of the traction motor V/W 24 / 1000 24 / 1000
Maximum forward speed Km/h 8 8
Maximum gradient with full load % 10 10
Electrical characteristics of the vacuum motor V/W 24 / 420 24 / 420
Suction vacuum (hole Ø0) mbar 85 85
Solution tank volume l 156 156
Recovery tank volume l 138 138
Detergent tank volume (version with dosing system only) l 5 5
Turning circle mm 1010 1010
Maximum machine length (without bumper kit) mm 1796 1796
Maximum machine height (without roof) mm 1245 1245
Maximum machine width (without squeegee) mm 900 1055
Battery Compartment Dimensions (Length x Width x Height) mm 430x630x470 430x630x470
Rated battery voltage V 24 24
Battery hopper weight kg 238 238
Machine weight kg 340 340
Transported machine weight kg 578 578
Machine weight in running order kg 815 815
Sound pressure level (ISO 11201) dB (A) 65.4 65.4
Uncertainty Kp
A
dB (A) 1.5 1.5
Body vibration level m/s
2
< 0.5 < 0.5
SPECIAL EQUIPMENT
Each design is created with the aim of giving the customer a new reason to choose Comac spa products, this type of scrubbing machines in particular can be equipped with the following devices:
• ECO-MODE: a device that decreases the noise level and lowers energy consumption.
The paragraphs in the document that talk about the following equipment will have the wording “ECO-MODE”.
• COMAC DOSING SYSTEM: this is the dosing system for the separate management of water and detergent, and allows you to increase or reduce the delivery depending on the dirt to be treated.
The paragraphs in the document that talk about the following equipment will have the wording “CDS”.
• PRESSURE MONITORING: a system that monitors the power dispensed by the brush motors in order to guarantee maximum eectiveness on any type of oor.
The paragraphs in the document that talk about the following equipment will have the wording “PM”.
• COMAC FLEET CARE: system that allows the remote control of machines status: if, when and where each machine is operating or if maintenance is needed, to let you promptly intervene avoiding machine
downtimes and unexpected costs for extraordinary maintenance.
13
To Next Page
Loading...
