COMAC OPTIMA 85B - Machine Deactivation and Maintenance Safety; Deactivating the Machine; Maintenance Safety Guidelines

• Before starting to work check that there are no leaks.
• Before starting to work check that all the safety devices have been installed and are working
correctly.
• Before starting work check that the brakes and steering are working correctly.
• Before starting work adjust the seat and steering wheel, and also the seat belt if there is one.
DEACTIVATION OF THE MACHINE
WARNING:
• Always protect the machine against sunlight, rain, and other atmospheric agents, both while it
is stationary and while it is in function. Store the machine in a dry, sheltered place: this machine
is only designed for use under dry conditions, and must not be used or stored outdoors under
humid conditions.
• Do not park the machine near combustible materials, powders, gases or liquids.
• Stop the machine on a at surface.
• If the machine is left unattended, it must be protected from any accidental movements
ATTENTION:
• The machine must only be stored under temperature conditions ranging from 0 °C to +40 °C or
+32 °F to 104 °F. The humidity level must be between 30% and 95%.
MAINTENANCE
DANGER:
• In order to avoid short-circuits when working in the vicinity of electrical components, do the
following: avoid the use of non-insulated tools; do not place or allow metallic objects to fall upon
the electrically powered components; remove any rings, watches and/or clothing with metallic
parts that might come into contact with the electrically powered components.
• do not work underneath the raised machine without adequate xed safety supports.
WARNING:
• Read all the relevant instructions carefully before performing any maintenance/repair operations.
• If the machine does not work properly, check this is not caused by failure to carry out routine
maintenance. Otherwise, ask for intervention of the authorised technical assistance centre.
• Restore all electrical connections after any maintenance interventions.
CAUTION:
• When doing maintenance work, switch o󰀨 the machine using the main switch. Remove the
key from the instrument panel and remove the battery connector from the electrical system
connector.
• Avoid contact with moving parts. Do not wear loose clothing or jewellery and tie long hair back.
• Block the wheels before lifting the machine.
• Lift the machine with equipment that can sustain the weight to be lifted.
7