ATTENTION:
• All maintenance operations on the machine must be carried out under sucient visibility and
lighting conditions.
• Ensure that the area used for the maintenance of the machine is well ventilated.
• Avoid contact with moving parts during machine maintenance. Do not wear loose clothing or
jewellery and tie long hair back.
• Block the wheels before lifting the machine with the jack.
• Raise the machine with the jack only at the points indicated. Support the machine using the
stands.
• Wear personal protective equipment as required and as suggested in the manual.
• Never tamper with the machine's protection devices for any reason; always follow the supplied
routine maintenance instructions scrupulously.
• If the machine needs to be pushed for maintenance purposes (batteries absent; discharged
batteries; etc.), never exceed 4 km/h or 2.49 mph.
• If any issues are encountered while using the machine, check to make sure that these are
not due to a lack of proper maintenance. Otherwise, request the intervention of authorized
personnel or an Authorized service centre.
• If any parts need to be replaced, always request ORIGINAL spare parts from an authorized
Dealer or Retailer.
• In order to ensure the machine's safety and proper functionality, always have the scheduled
maintenance interventions (specied in the appropriate section of this Manual) performed by
authorized personnel or by an authorized Service Centre.
• Do not clean the machine with direct or pressurized jets of water, or with corrosive substances.
• Disconnect the battery connection and the battery charger cable before working on the machine.
• If lead batteries (WET) have been installed on the machine, avoid tilting the machine beyond
30° with respect to the horizontal plane, as this could cause the highly corrosive liquid to leak
out of the batteries.
• Avoid contact with the battery acid.
• Keep all metal objects away from the batteries.
• Use a non-conductive device for removing the battery.
• Use a hoist and suitable equipment when lifting the batteries.
• The battery must be installed by qualied personnel.
• Always observe the safety measures of the site regarding removing the battery.
• Remove the batteries if the machine needs to be tilted in order to perform maintenance
procedures.
• Have the machine checked by an authorised technical assistance centre every year.
• When disposing of consumable materials, observe the laws and regulations in force. Once
the machine has reached the end of its service life, the materials contained within it must be
disposed of in an appropriate manner, keeping in mind that the machine itself has been built
using fully recyclable materials.
• Do not push or tow the machine without an operator on the seat who can control the machine.
• Do not wash the machine with pressurised water or wet the machine near electrical components.
• All repairs must be carried out by qualied personnel.
• Do not physically change the design characteristics of the machine.
• Use spare parts supplied by Comac or by Comac service centres.
• Wear personal protective equipment as required and as suggested in the manual.
8
To Next Page
Loading...
