On consignment of the machine
When the machine is delivered to the customer, an immediate check must
be performed to ensure all the material mentioned in the shipping
documents has been received, and also to check the machine has not
been damaged during transportation. If this is the case, the carrier must
ascertain the extent of the damage at once, informing our customer
service office. It is only by prompt action of this type that the missing
material can be obtained, and compensation for damage successfully
claimed.
Intended use
The scrubbing machine is designed exclusively for the professional
cleaning of surfaces and floors in industrial, commercial and public
environments. The machine is only suitable for use in closed (or at least
covered) places.
The machine is not suitable for use in the rain, or under water jets. It is
FORBIDDEN to use the machine in places with a potentially explosive
atmosphere, for picking up dangerous dusts or inflammable liquids. In
addition, it is not suitable as a means of transport for people or objects.
Introductory comment
S
IMPLA 2009 is a floor scrubbing machine which, by means of the
mechanical action of the rotating brush and the chemical action of a
water/detergent solution, can clean any type of flooring. As it advances, it
also collects any removed dirt as well as the detergent solution not
absorbed by the floor.
The machine must be used only for this purpose. Even the best
machines will only work well if used correctly and kept in good working
order. We therefore suggest you read this instruction booklet carefully and
read it again whenever difficulties arise while using the machine. If
necessary, remember that our assistance service (organised in
collaboration with our dealers) is always available for advice or direct
intervention.
Serial number plate
TECHNICAL DESCRIPTION UM SIMPLA 55BT SIMPLA 65BT SIMPLA 50BST
Rated power W 1260 1260 1300
Working width mm 560 660 500
Width of rear squeegee mm 760 948 760
Work capacity m
2
/h 2240 2640 2000
Brushes (diameter or length)
mm
290 340 110x500
Brush rotations rpm 190 190 700
Pressure on the brushes kg 30-40 30-40 30-40
Brush motor V / W 24/560 24/560 24/600
Type of advance autom autom autom
Maximum gradient % 10% 10% 10%
Movement speed km/h 0-4 0-4 0-4
Suction motor V / W 24/330 24/330 24/330
Suction vacuum mbar 90 90 90
Traction motor V / W 24/150 24/150 24/150
Solution tank PE l 55 55 55
Recovery tank PE l 62 62 62
Total machine weight (empty and without batteries) kg 125 125 140
Machine weight in running order (machine + batteries + water)
To Next Page
Loading...
