Having finished the job and before any type of maintenance is done:
1. Close the tap
2. Raise the brush base
3. Switch off the brushes motor switch
4. Switch off the solenoid valve switch
5. Place the squeegee switch onto manual
6. Lift the squeegee
7. Switch off the suction motor switch
8. Bring the machine up to the place provided for the water outlet
9. Turn the key 1/4 round counter clockwise
1. Take off the exhaust pipe from its hook, unscrew the exhaust plug and empty the recovery tank.
To simplify draining operation, it is recommended to hold the hose bent with one hand and with
the other unscrew the knob and take off the plug. Slowly straighten the hose and the liquid will
start draining at the desired speed. This operation has to be carried out using gloves to protect
from contact with dangerous solutions.
To perform this operation wear the protection gloves to prevent contacts with
dangerous liquid
1. The squeegee has to be lifted when the machine is not operating. In this way damage to the
squeegee rubbers is avoided.
2. Take off the brushes and clean them with a water jet (for the brushes disassembly please read
further on under “DISASSEMBLY OF THE BRUSHES”).
To Next Page
Loading...
