DAILY MAINTENANCE
3. REPLACING THE SQUEEGEE RUBBERS
Verify that the state of wear and tear of the squeegee rubbers and, if necessary, replace them. To
replace them you must:
1. Raise the squeegee
2. Remove the two knobs
3. disassemble the squeegee from its support
4. Remove the tube from the squeegee nozzle so the squeegee can be removed
WARNING: Before carrying out any type of maintenance,
disconnect the machine's battery connector.
WARNING: this operation must be carried out by using gloves in
order to protect against contact with dangerous solutions
5. unscrew the knobs on the squeegee that block the rubber-pressing blades, and remove them
6. remove the rubber-pressing blades
7. replace the rubbers
8. reassemble everything, carrying out the above-mentioned operations in the reverse order
WARNING: Before carrying out any type of maintenance,
disconnect the machine's battery connector.
WARNING: this operation must be carried out by using gloves in
order to protect against contact with dangerous solutions
To Next Page
Loading...
