IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
Setpoint: SMTP address
CAUTION!
Proper setting of SMTP-related setpoints as well as controller mailbox are
essential for sending alerts via e-mails.
This setpoint is used for entering the domain name (e.g. smtp.yourprovider.com)
or IP address (e.g. 74.125.39.109) of the SMTP server. Please ask your internet
provider or IT manager for this information.
NOTE:
You may also use one of free SMTP servers, e.g. smtp.gmail.com. However,
please note that some free SMTP servers may cause delays (in hours..) when
sending e-mails.
NOTE:
If you do not want to send active e-mails, you may leave this setpoint blank, as
well as other setpoints related to SMTP server and e-mail settings.
Setpoint: Contr mailbox
Enter an existing e-mail address into this setpoint. This address will be used as
sender address in active e-mails that will be sent from the controller. Do not
enter your or other recipient's e-mail address. Recipient's addresses are to be
entered into the setpoints AcallCH1-Addr, AcallCH2-Addr and AcallCH3-Addr.
NOTE:
Most of SMTP server will reject sending e-mails that contain nonexisting address
in the sender address field.
Setpoint: Time zone
This setpoint is used to select the time zone where the controller is located. See
your computer time zone setting (click on the time indicator located in the
rightmost position of the the windows task bar) if you are not sure about your time
zone.
NOTE:
If the time zone is not selected properly the active e-mails may contain incorrect
information about sending time, which may result in confusion when the
respective problem actually occured.
To Next Page
Loading...
