InteliLite Global Guide
142
SMS
Event SMS
The InteliLite controller equipped with the CM-GPRS or CM-4G-GPS communication module is able to send
Event SMS according to the setting of setpoint:
Event Message (page 374)
Note: Firstly setpoint Telephone Number 1 (page 368) has to be adjusted.
The following events can be received by mobile phone:
Engine Start/Stop
Manual Start/Stop
Remote Start/Stop
Load on Gen-set
Message structure:
Genset Name (hh:mm:ss dd.mm.yyyy)
hh:mm:ss Load on Genset
Alarm SMS
The InteliLite controller equipped with the CM-GPRS or CM-4G-GPS communication module is able to send
Alarm SMS according to the setting of setpoints:
Wrn Message (page 375)
Sd Messages (page 375)
BOC Message (page 375)
Note: Firstly setpoint Telephone Number 1 (page 368) has to be adjusted.
Message structure:
Gen-set Name
AL=(Alarm 1, Alarm 2, Alarm x)
Note: Asterisk means that alarm is unconfirmed and exclamation mark means that alarm is active.
SMS commands
To control the gen-set equipped with InteliLite controller and CM-GPRS or CM-4G-GPS communication module
(or modem) via SMS requests, send an SMS in the structure of:
# xxxx, yyyy, zzzz, etc.
SMS send to the telephone number of the SIM card in your CM-GPRS module (or modem). Where the “#” mark
means the controller access code, “xxxx” means the Command 1, “yyyy” is Command 2, “zzzz” is Command 3,
etc.
Note: Access code is set up via InteliConfig.
IMPORTANT: If wrong controller access code is set, then only help command is working.
To Next Page
Loading...
Need help?
General
