ComAp intelilite nt amf20 User Manual

InteliLite
NT
– AMF20/25, SW version 2.2, ©ComAp – September 2014 123
IL-NT-AMF-2.2-Reference Guide.pdf
Code
Description
0
OK. No error.
1
Not possible to hang up.
2
IL-NT-GPRS is switched off
3
IL-NT-GPRS is switched on
4
IL-NT-GPRS – error in initialization
5
IL-NT-GPRS – not possible to set the APN
6
IL-NT-GPRS – not possible to connect to GPRS network
7
IL-NT-GPRS – not possible to retrieve IP address
8
IL-NT-GPRS – not accepted DNS IP address
9
Error in modem detection
10
Error in initialization of analog modem
11
SIM card is locked (Possibly PIN code required, PIN needs to be deactivated) or unknown
status of SIM locking
12
No GSM signal
13
Not possible to read the SIM card parameters
14
GSM modem did not accepted particular initialization command, possibly caused by
locked SIM card
15
Unknown modem
16
Bad answer to complement initialization string
17
Not possible to read GSM signal strength
18
CDMA modem not detected
19
No CDMA network
20
Unsuccessful registration to CDMA network
23
Controller couldn´t detect IL-NT GPRS module communication speed.
255
Only running communication is needed to indicate
 AirGate Diag – Diagnostic Code for AirGate connection
Table of Diagnostic Codes:
Code
Description
0
Waiting for connection to AirGate Server
1
Controller registered, waiting for authorization
2
Not possible to register, controller blacklisted
3
Not possible to register, server has no more capacity
4
Not possible to register, other reason
5
Controller registered and authorized
SMS Commands
To control the gen-set equipped with InteliCompact
NT
controller and IL-NT GPRS communication
module (or modem) via SMS requests, send an SMS in the structure of:
# xxxx, yyyy, zzzz, etc.
to the telephone number of the SIM card in your IL-NT-GPRS module (or modem). Where the “#” mark
means the controller access code, “xxxx” means the Command 1, “yyyy” is Command 2, “zzzz” is
Command 3, etc.
Table of SMS requests:
start
Start the engine in MAN mode.
stop
Stop the engine in MAN mode.
fault reset
Acknowledging alarms and deactivating the horn output.
gcb close
Closing GCB in MAN and TEST mode.
gcb open
Opening GCB in MAN and TEST mode.
mcb close
Closing MCB in MAN and TEST mode (only in IC-NT SPTM).
mcb open
Opening MCB in MAN and TEST mode (only in IC-NT SPTM).
off
Switching to OFF mode.

ComAp intelilite nt amf20 Specifications

General

Brand	ComAp
Model	intelilite nt amf20
Category	Controller
Language	English