ComAp IS-NT-BB

IGS-NT-BC, SW Version 1.2.0, ©ComAp – January 2019
IGS-NT-BC-1.2.0 Reference Guide.PDF
175
Value: Reg16
Group
Info
Units
-
Related FW
3.0
Description
Bits of this value show "1" if the controller which has address corresponding with
the bit position plays active role in the power management. Bit 0 represents
address 1 etc. This value contains information about controllers with addresses 1-
16.
Value: Reg32
Group
Info
Units
-
Related FW
3.0
Description
Bits of this value show "1" if the controller which has address corresponding with
the bit position plays active role in the power management. Bit 0 represents
address 17 etc. This value contains information about controllers with addresses
17-32.
Value: GL16
Group
Info
Units
-
Related FW
3.0
Description
Bits of this value show "1" if the bank controller which has address corresponding
with the bit position has BCB closed. Bit 0 represents address 1 etc. This value
contains information about controllers with addresses 1-16.
Value: GL32
Group
Info
Units
-
Related FW
3.0
Description
Bits of this value show "1" if the bank controller which has address corresponding
with the bit position has BCB closed. Bit 0 represents address 1 etc. This value
contains information about controllers with addresses 17-32.
Value: Engine state
Group
Info
Units
-
Related FW
3.0