IGS-NT-BC, SW Version 1.2.0, ©ComAp – January 2019
IGS-NT-BC-1.2.0 Reference Guide.PDF
#1) backlight is switched off.
NOTE:
When IntelliVision is used this setpoint does not adjust its behavior. Its backlight is
adjusted by internal IntelliVision "setpoint".
The backlight is off all the time
The backlight is on all the time
If this setpoint is in ENABLED position the display backlight is temporarily
switched off during gen-set start.
This setpoint adjusts the rate of increasing of the PulseCounter #1 module. The
module counts pulses at the input PulseCounter 1 and if the input pulses counter
reaches value given by this setpoint, the counter value PulseCounter 1 (in the
group Statistic) is increased by 1 and input pulses counter is reset to 0. Both
counter value and input pulses counter are stored in the nonvolatile memory.
This setpoint adjusts the rate of increasing of the PulseCounter #2 module. The
module counts pulses at the input PulseCounter 2 and if the input pulses counter
reaches value given by this setpoint, the counter value PulseCounter 2 (in the
group Statistic) is increased by 1 and input pulses counter is reset to 0. Both
counter value and input pulses counter are stored in the nonvolatile memory.
To Next Page
Loading...
