Mains pro 1.6.1 Global Guide
4
9.5 Start trip 42
9.6 TEST mode 42
10 Introduction of Reference Guide 44
10.1 Purpose of this manual 44
11 Technical data 45
11.1 Accuracies and reaction times 45
11.1.1 Operating area 45
11.1.2 Voltage measurement 46
11.1.3 Frequency measurement 46
11.1.4 Time delays accuracy 46
11.1.5 Loss of Mains reaction times 46
11.2 Technical parameters 46
11.2.1 Endurance to the power supply voltage fails 47
11.3 Factory default setting of MainsPro unit 47
12 Appendix 50
12.1 Library of Setpoints 51
12.1.1 Group: Basic 52
12.1.2 Group: V <>, A.V <> 55
12.1.3 Group: dU, A.dU 56
12.1.4 Group: f <>, A.f <> 57
12.1.5 Group: LOM, A.LOM 58
12.1.6 Group: f(BI) 59
12.1.7 Group: f(RE) 60
12.2 Library of Binary switches 61
12.2.1 Ext Trip 61
12.2.2 Fault Reset 61
12.2.3 Alt Settings 61
12.2.4 Disable 61
12.2.5 CB Feedback 61
12.3 Relay outputs 62
12.3.1 CommTrpPer 63
12.3.2 !CommTrpPer 63
12.3.3 CommTrpImp 63
12.3.4 !CommTrpImp 63
12.3.5 CommSigImp 63
12.3.6 !CommSigImp 64
12.3.7 CommSigDel 64
To Next Page
Loading...
