Mains pro 1.6.1 Global Guide
62
12.3 Relay outputs
The standard logic of MainsPro corresponds to the standard of protective relays and offers an option to set the
logic of the relay outputs. For safety reasons there are available full set of outputs marked with an exclamation
mark “!”, which remain energized in fault-free state and in case of power supply failure, the unit goes to “fault”
indication position - the output relay deactivates. MainsPro also allows setting the output relays to normal logic,
so the outputs maintain de-energized in fault-free state and in case of a trip, the relays energize.
12.3.1 CommTrpPer 63
12.3.2 !CommTrpPer 63
12.3.3 CommTrpImp 63
12.3.4 !CommTrpImp 63
12.3.5 CommSigImp 63
12.3.6 !CommSigImp 64
12.3.7 CommSigDel 64
12.3.8 !CommSigDel 64
12.3.9 U Sig 64
12.3.10 !U Sig 64
12.3.11 f Sig 65
12.3.12 !f Sig 65
12.3.13 LOM Sig 65
12.3.14 !LOM Sig 65
12.3.15 dU Sig 65
12.3.16 !dU Sig 66
12.3.17 Other Sig 66
12.3.18 !Other Sig 66
12.3.19 Alt Sig 66
12.3.20 TrpEndImp 66
12.3.21 !TrpEndImp 67
12.3.22 InternFail 67
12.3.23 !InternFail 67
12.3.24 BakTrpPer 67
12.3.25 !BakTrpPer 67
12.3.26 BakTrpImp 68
12.3.27 !BakTrpImp 68
6 back to Appendix
To Next Page
Loading...
