43
EN
The programming key is used when some reader settings need to be changed
without connecting the reader to the UNICO program. When the key and
correct manager code are entered, the yellow LED comes on and when the
programming is finished the yellow LED goes off and the green one comes on
flashing every second. At this point the key can be removed. After this
operation the reader carries out an auto reset operation so as to restart with
the new configuration with the red LED on.
When an Key Audit
or programming key without a user code is inserted, the
red flashing LED (1s) comes on
When all the LEDs flash together it means the key or card must be re-inserted
in the reader
When an audit key or programming key is inserted and the programming key is
correct, the yellow LED stays on fixed for the entire time during which the data
is being stored on the key. When the transfer has finished, the yellow LED goes
off and the green LED comes on flashing every second
To Next Page
Loading...
