World Key/World Key Lite/World Key Move - operating manual
44
7. Programming and data collection
7.1 Programming
UNICO software, the programming key and the Clone programming key are used to
program the World Key, World Key Lite and World Key Move devices. UNICO AUDIT
and UNICO CARD software is used respectively to manage the media, both keys and
cards, and accounting.
World Key, World Key Lite and World Key Move can be connected to a PC which has
UNICO software installed on it by means of the USB port. The devices are also
powered through the USB port. Therefore if no other peripherals are connected, no
external power supply is required.
7.1.1 Safety codes
A safety code is required to access device configuration and to read or modify the
entered data. There are three configuration levels which can be accessed through
three different codes to manage different privilege/access levels.
Administrator Code: numerical code which identifies a single administrator and allows
access to all machines in all rentals managed by him.
Rental Code: numerical code which identifies a single area managed by a single
administrator.
Access Code: numerical code which identifies a subarea in a single rental managed
by a single administrator.
When leaving the factory, all codes of each device consist in a sequence of zeros.
These codes must be modified before activating the devices to prevent tampering or
frauds.
N.B.:
The safety codes are necessary to access device configuration.
If they are lost, they cannot be recovered and the device must be reset completely.
It is therefore recommended to write down the safety codes and to keep them in a safe
place.
7.1.2 Programming with UNICO software
The use of UNICO software is described in detail in the specific manual.
To Next Page
Loading...