Comestero RM5 HD - Page 26

RM5 HD – Operating Manual
26
Fig. 18
The protocol provides no procedure to manage peripheral devices. This is left to the
common sense of the Host programmer. For example, to avoid replacing the coin
mechanism or any other device, it may be sufficient that, when started up, the
machine interrogates its peripheral device about serial numbers, product code,
manufacturer code, etc. If all the information received from the peripheral devices
corresponds with the information stored in the host, all activities may continue,
otherwise they may be inhibited and the necessary measures will be taken. RM5 HD
implements the controls described below.
The table below shows two different sets of controls for the ccTalk Giochi Italia and
ccTalk other configurations (Full) versions.
Header Custom
Control
Gaming-
ITALIA
Other
Config.
1
Reset device X X
2
Request comms status variables X X
3
Clear comms status variables X X
4
Request comms revision X X
169
Request address mode X X
170
Request base year X X
183
Upload window data X
184
Request coin id X X
185
Modify coin id X
188
Request default sorter path X X
189
Modify default sorter path
1
X X
192
Request build code X X
193
Request fraud counter X X
194
Request reject counter X X
195
Request last modification date X X
196
Request creation date X X
197
Calculate ROM checksum X X
198
Counters to EEPROM
2
X X
201
Request teach status X
202
Teach mode control X
1
Stored in Flash
2
Stores the current counter values in flash