Commend GEC 880 - Page 22

The station GEC 880
Page 22 of 24 Version 1.1/1107
Gong at outside area
n During the gong signal conversation is not possible (in both directions).
n If a gong is initiated during a conversation, the conversation is re-
established when the gong is over.
Setting of Station Parameters
The following parameters can be set:
The selected parameters are automatically saved. Even when the power
supply is disconnected the selected parameters remain stored.
Acknowledgement tones
There are two types of acknowledgement tones:
n “Beep” = OK
n “Boing” = not available
At the buttons
 and  no acknowledgement tones are audible.
Button Function Display

Press to trigger a gong signal at the outside loud-
speaker(s) to attract the attention of customers.
GONG

Press to abort the gong signal immediately.
Button Function

Press to enter the user settings mode. Press the button again to
cycle through the parameters.

Press to decrease the value of the current parameter.

Press to increase the value of the current parameter.

Press to exit the parameter settings mode at any time.
Parameter settings mode is automatically quit after 5 seconds of
inactivity.
Parameter Description Value range
ACK
ACKnowlegement tones:
“Keypad tones” ON/OFF
0....OFF
1....ON
LCD Adjustment of LC-display contrast 1 ....10
LED
Brightness of the LED see ”
Day / Night Mode”
on page 21
1....10
VCI
Volume Chimes Internal:
Volume level for playback of chimes at the
inside station
1....10
VEB Volume of the outside station in BOOST-mode 1 ....13
VEX Volume of the outside station 1 ....13