GEC 880 FAQ
Version 1.1/1107 Page 23 of 24
Bell Signal
For this function the outside area must be equipped with a call button or
proximity switch and the station must be programmed by the technician.
FAQ
Q: An active conversation is automatically quit after a certain time without
conversation or key press. How can I deactivate or enlarge this time?
A: This time has been programmed by the technician and can only be
changed by him (standard = 20 seconds). Please contact your service
technician.
Q: An alarm tone is played back at the station or the outside area or both.
What does this mean?
A: This alarm shall signalize that a component of the outside station part
(outside microphone) has failed or has been tampered with. Contact
your service technician as soon as possible!
Q: My display is showing strange digits or all display segments. How can I
solve this?
A: If display indication is strange or faulty try pressing . Otherwise the
contrast of the display could be set too high (see ”
Setting of Station Pa-
rameters” on page 22). If this does not help, disconnect and reconnect
the power supply of the station. If this does not change operation back
to normal, please contact your service technician.
Q: Why is my station operating strangely?
A: Disconnect and reconnect the power supply of the station. The BOOT-
sequence, as described on page 19
, should be carried out. If this does
not change operation back to normal please contact your service techni-
cian.
Q:
Can the bell signal be played back louder than the incoming conversation?
A: Yes. Choose a higher volume level for VCI (see ”Setting of Station Para-
meters” on page 22) than for VIN (see ”Volume settings” on page 21).
Situation Function Display
Customer presses call button
or enters outside area (when a
proximity switch is used)
Bell signal is audible (in HEADSET
MODE: at the internal loudspeaker
as well as the headset)
BELL
To Next Page
Loading...
